Home Recording Studio Center

The Shure KSM353/ED is a premium bi-directional ribbon microphone crafted for pristine audio in studio and concert hall applications. Proprietary Roswellite(TM) technology provides revolutionary ribbon resilience and durability under extreme conditions.

Click here to learn more about Shure KSM353/ED Ribbon Microphone

he only ribbon mic with true top end! Over five years in development, the Blue Microphones Woodpecker Ribbon Microphone is the only choice when searching for the smoky, warm, classic sound of a ribbon, but without sacrificing the bright presence of top-end.

Click here to learn more about BLUE Woodpecker Ribbon Microphone

Incorporating a Figure 8 polar pattern and a 1.8-micron aluminum ribbon, the R144 offers breathtaking sound for vocal and instrument recordings and is an excellent microphone for broadcast applications. The R144 also performs brilliantly on acoustic instruments, strings, and horns and offers high SPL capability, outstanding side rejection and precise directivity.

Click here to learn more about MXL R144 Ribbon Microphone

With the groundbreaking AT4080, Audio-Technica achieves the coveted ribbon microphone sound while solving the problems of fragility and low output that have historically plagued ribbon mics. Delivering the warm, smooth sound of a classic ribbon microphone, Audio-Technica’s handcrafted AT4080 Ribbon Microphone offers a robust build for long-lasting, reliable performance and higher output for maximum compatibility with microphone preamplifiers.

Click here to learn more about Audio Technica AT4080 Bidirectional Ribbon Microphone with Shockmount

The Golden Age Project R-2 MkII Microphone is quite different from the R-1 series of mics. It features a ribbon transducer with a shorter and more narrow ribbon. It is darker sounding than the R-1 series since the higher frequencies roll off earlier.

Click here to learn more about Golden Age Project R-2 MKII Ribbon Microphone

The Shure KSM313/NE is a premium bi-directional ribbon microphone for world-class audio and performance. The Dual-Voice design features discrete front-and-rear side sonic signatures for use with amplified instruments or in intimate vocal applications.

Click here to learn more about Shure KSM313/NE Dual Voice Ribbon Microphone

Elevate your sound with the Cloudlifter. Recording with ribbon mics has never been easier. Designed by Stephen Sank to interface passive low output ribbon microphones with any phantom powered input device, it is completely safe for all passive microphones. The Cloudlifter takes the level of your low output ribbon microphone and lifts it over 20db. They work well with dynamics and ribbons alike, offering two channels of world class initial pre-amplification for any passive signal.

Click here to learn more about Cloud Microphones Cloudlifter Ribbon Microphone Preamplifier

Delivering the warmth and natural sound of a classic ribbon microphone, Audio-Technica’s handcrafted AT4081 offers a robust build for long-lasting performance and higher output for maximum compatibility with microphone preamplifiers. With its low-profile stick design, this microphone is a natural for use on a wide range of instruments (horns, strings, drum overheads, orchestras and more) and guitar cabinets in recording studios and live-sound settings.

Click here to learn more about Audio Technica AT4081 Bidirectional Ribbon Microphone with Clamp

The R1 MKII is a high quality vintage style ribbon microphone. It offers the unique and natural sound that has been available in classical microphones like the RCA 44 and 77 that are still used to make high quality recordings today, after almost 70 years.

Click here to learn more about Golden Age R-1 MKII Ribbon Microphone

The newest series from CAD, all Trion mics feature dual diaphragms and come in 3 different flavors. The Trion 7000 is dual ribbon microphone with with great articulation.

Click here to learn more about CAD Trion 7000 Dynamic Dual Element Ribbon Microphone

Incorporating a Figure 8 polar pattern and a 1.8-micron aluminum ribbon, the R144 ribbon mic offers breathtaking sound for vocal and instrument recordings. It’s an excellent microphone for broadcast applications and also performs brilliantly on strings, horns, acoustic guitars, and other acoustic instruments. The MXL R-144 offers high SPL capability, outstanding side rejection and precise directivity.Figure 8 polar pattern for outstanding side rejection and precise directivityHigh SPL capabilityDelivers an unbelievably natural sound and stunning realism for vocal and instrument recordingsDistinctive body design with purple and chrome metal finishIncludes R144 ribbon microphone, shockmount, carrying case, cleaning cloth, manual, & application guideWired with Mogami cableRecommended for:VocalsElectric guitarPercussionStringsBrass horns

Click here to learn more about Mxl R144 Ribbon Microphone

A modern classic, the MXL 990 Ribbon mic is the result of great engineering. With an amazingly smooth and natural frequency response, the 990 Ribbon mic excels in the most demanding recording applications. It can be used to enhance string and woodwind instruments, along with mellow, edgy vocals and overly bright horns. It is equally at home when used in conjunction with a grand piano or even in front of a guitar cabinet pushing high SPL levels. When it comes to unprecedented versatility, the MXL 990 ribbon mic is a top-notch choice.The MXL 990 Ribbon microphone uses an aluminum ribbon transducer, which by nature is a bidirectional (figure-8) pickup pattern. A figure-8 pattern will pick up sounds from the front and back sides of the microphone with equal sensitivity while maintaining a large amount of rejection 90 degrees off access. The front of the microphone is indicated by the MXL logo where the audio signal is in-phase while the backside has an inverted phase. Ribbon mics typically have a lower output than condenser microphones and may require a preamplifier with a lot of gain. It is highly recommended to use a preamp with low noise, high gain, and an input impedance of 1500 or greater. It is strongly advised to experiment with placement and isolation requirements with the gain initially set low to avoid possible equipment (and hearing) damage.Important Power RequirementsThis microphone does not require a power supply. Use of phantom power with this microphone is not recommended as it can severally damage the ribbon element and causes the microphone to be unusable.Aluminum ribbon transducerBidirectional (figure-8) pickup patternLarge amounts of rejection 90 degrees off accessThe front of the microphone is where the audio signal is in-phase while the backside has an inverted phaseSmooth and natural frequency responseDoes NOT require a power supplyDo NOT use phantom power, which will severely damage the microphoneWired with Mogami cable

Click here to learn more about Mxl 990 Ribbon Microphone

A modern classic, the MXL 990 Ribbon mic is the result of great engineering. With an amazingly smooth and natural frequency response, the 990 Ribbon mic excels in the most demanding recording applications. It can be used to enhance string and woodwind instruments, along with mellow, edgy vocals and overly bright horns. It is equally at home when used in conjunction with a grand piano or even in front of a guitar cabinet pushing high SPL levels. When it comes to unprecedented versatility, the MXL 990 ribbon mic is a top-notch choice.The MXL 990 Ribbon microphone uses an aluminum ribbon transducer, which by nature is a bidirectional (figure-8) pickup pattern. A figure-8 pattern will pick up sounds from the front and back sides of the microphone with equal sensitivity while maintaining a large amount of rejection 90 degrees off access. The front of the microphone is indicated by the MXL logo where the audio signal is in-phase while the backside has an inverted phase. Ribbon mics typically have a lower output than condenser microphones and may require a preamplifier with a lot of gain. It is highly recommended to use a preamp with low noise, high gain, and an input impedance of 1500 or greater. It is strongly advised to experiment with placement and isolation requirements with the gain initially set low to avoid possible equipment (and hearing) damage.Important Power RequirementsThis microphone does not require a power supply. Use of phantom power with this microphone is not recommended as it can severally damage the ribbon element and causes the microphone to be unusable.

Click here to learn more about MXL 990 Ribbon Microphone

The Nady RSM-8A is a ribbon mic that offers all the warmth and natural, uncompromising sound expected of a classic Nady ribbon microphone. You also get the added gain and selectable features offered by proven ultra low-noise FET active circuitry and transformer output. This Nady mic is perfect for recording vocals, acoustic and electric guitars, drums, percussion, strings, and brass—for any application in which true natural audio reproduction is desired.

Click here to learn more about Nady RSM-8A Ribbon Microphone

The Nady RSM-8A is a ribbon mic that offers all the warmth and natural, uncompromising sound expected of a classic Nady ribbon microphone. You also get the added gain and selectable features offered by proven ultra low-noise FET active circuitry and transformer output. This Nady mic is perfect for recording vocals, acoustic and electric guitars, drums, percussion, strings, and brass – for any application in which true natural audio reproduction is desired.Low-tension 50mm long, 2-micron thick aluminum ribbon design Over 40dB higher gain than most non-active ribbon microphones -10dB pad and Low Cut filter selector switches Unmatched fast, accurate transient response 165 dB SPL capability Figure-8 audio directional pickup pattern Swivel U-bracket allows easy positioning Machined housing and advanced internal shockmount construction 48V Phantom Power required

Click here to learn more about Nady Rsm-8A Ribbon Microphone

The R-1 SM shock mount, designed for Golden Age’s R-1 Ribbon Mic, provides noise free usage for your recordings. A shock mount provides much needed isolation from the room making your recordings sound their best.

Click here to learn more about Golden Age R-1 SM Shockmount for R1 Ribbon Microphone